Grain dryer unit processes:
First, the device according to the dryer needs to be stringent standards on the assembly drawing and foundation construction figure , former dryer unit , its components and its response to adjuvant Yigai parts inventory , wiping , finishing clean and fully equipped.
Second, because the dryer is a long body of large equipment , which means and methods should be carried out in this order:
1. designated root Bottom line: the right to cross the line , elevation lines, standard plate in the middle of laying the foundation board to reach using standard convenience , accurate and not think about the base unit is withheld.
2. the device base and tug : leveled horn orientation , draw the base, the middle line tugboat , in accordance with the drawings needs , identify the base and the tug of device orientation , positive tone flat , first foundation hole grouting , concrete reach a certain intensity when , tighten the bolt, after the review of qualified, then the device cylinder .
3. the device cylinder and rolling circle : first rolling ring mounted on the cylinder, when the demand stick concave joints staggered to a positive and negative equipment and adjust the thickness of the horn , the touch ring and the concave roll joints persist corresponding gap , not common , and spot concave joint bolt head and the cylinder body .
4. the device gear : Front view butt plane interface device shall not bump marks, the big gear and the outer cylinder wiping clean the touch , then beware of the two halves of good gear and tighten the connector screws , put the gear mounted on the barrel body . Shift cylinder, check runout and lateral swing gear until calibrated qualified.
5. the device pinion , speed reducer, motor: has assembled a large gear , adjust large pinion meshing parameters and rules needs to reach the equipment , fixed pinion gear position based on electromechanical machines .
6. the device gear cover to marginal gear spacing symmetry.
Large Drying Plant & Free Customization